OWANDY RX - HUMAN VERSION
Page 21 of 61
OPERATOR’S MANUAL • Owandy-RX DC • 02/2020 • NXDCEN160A
Operator’s manual – Owandy-RX DC
INSTRUCTIONS FOR USE
4.1. INSTRUCTIONS FOR USE
1° - TURN ON
Bring the main switch located on the upper part of the timer to the “I” position (ON)
1. the green light turns on, indicating that the system is powered
2. the LEDs of the set parameters automatically light up
3. the exposure time is shown on the display
CAUTION
If an error is detected when the system is turned on, please refer to Chapter 8 ERROR MESSAGES of this Manual
PLEASE NOTE
The exposure time and parameters which appear on the display are the last that were set before the timer was turned off.
If the timer remains inactive for a few minutes, it switches to the stand-by mode.
Press any key on the control panel to restore it to the operative mode.
2° - CHECK THE SELECTED PARAMETER
Before making the exposure, check that the parameter selected on the control panel (from Step 1 to Step 8) are suitable
for the radiographic exam.
STEP 1 : check the selected tubehead
The LED of the desired tubehead should be turned on
LED
Rx 1 ON
indicates that the tubehead connected to the timer X-ray1 terminal block is selected
LED
Rx 2 ON
indicates that the tubehead connected to the timer X-ray2 terminal block is selected
to change the selection press again the button
