e1d/24a0,
;Current Cell ID
Note: This command usually be used to check the tracker current status & configuration, if the
tracker can not work well, this command can check what the problem is.
11. Reset the tracker
Send SMS
“RESET*12345678” to tracker can make the tracker power off and power on again,
“RESET” is the fixed command,
“
12345678
”
is password. The tracker will send back information
“Cancel all alarm setting and re-power on”, then the tracker will power off and power on automatically,
if the password is not right, the operation is fault, the tracker will send back information
“Wrong
Password
”. some time the tracker can not work properly, send the reset command, the tracker will re-
power on a few minutes later.
12. Restore to factory setting (Back to Default)
Send SMS
“FACTORY*12345678” to tracker can make the tracker power off and power on
again,
“FACTORY” is the fixed command,
“
12345678
”
is password. The tracker will send back
information
“Setting back to factory default”, then the tracker will delete all user setting, and restore all
setting to factory mode, just like a new tracker, then the tracker will re-power on after delete user setting.
If the user have changed the setting, such as APN, IP, authorized number, etc, you need set this again
after back to factory mode. if the password is not right, the operation is fault, the tracker will send back
information
“Wrong Password”.
Notes:
1. Please confirm that the SIM card PIN code has been disabled, it means if mobile phone use
this SIM card, it is not necessary to input any password. Otherwise the tracker can not find
GSM or CDMA network, the Green LED will keep ON .
-
12
-
