Overmax X-bee 9.5, User Manual

Page: 38 / 208

EN
B – How to assemble an airscrew rotating anti-clockwise
Assemble the airscrew marked as B in the corresponding motor (see: fig. 6).
Tighten up two screws with the use of a screwdriver and then put the protective
cover on and screw it in clockwise.
If the assembly of the device is wrong, the product will not fly properly and may
get damaged. Pay special attention to airscrews marking and their destination
on the drone. Use airscrews from the set or purchase them directly from the
manufacturer only.
How to disassemble airscrews
Immobilize the motor with a palm, unscrew and remove the protective cover.
Then unscrew both screws with the use of the screwdriver and finally remove
the airscrew from the device.
How to assemble chassis legs
To assemble legs, screw them to the lower casing (fig. 7).
How to assemble batteries
Insert the battery in the compartment at the back of the drone and press
it (fig. 8). The drone will activate (LED lights will go on and a sound will be
emitted). Slide the battery lock into „O” position to secure it and make sure
it has been fixed properly.
NOTE: Make sure the battery has been properly fixed in the drone,
otherwise the flight safety may be affected. The drone may also crash
due to power cut.
How to disassemble batteries
Slide the battery lock into „I” position and pull the battery to remove it (fig.
9). Do not touch the battery if your hands are wet.