Overmax X-bee 9.5, User Manual

Page: 37 / 208

EN
E
– GPS
ON – active GPS mode
OFF – inactive GPS mode
F
– Number of GPS satellites
When the drone connects to the sufficient number of satellites (at least 7), the
drone take-off spot is saved in the memory as „home”.
G
– Drone working mode
After take-off, the product enters „mode 2” by default.
H
– Speed mode
It indicates a selected drone flight speed mode - HIGH (high speed) or LOW (low speed).
I
– Photo/video
After you have taken a photo, the camera icon glows on the display for a while.
When recording a video, this icon flashes until you finish recording.
J
– Controller battery status
It shows controller battery status.
K
– Signal strength indicator
The icon shows a signal strength received by the controller.
L
– Headless mode / calibration
It indicates headless mode and device compass calibration.
Headless mode can be enabled in the mobile application.
How to assemble and disassemble drone
airscrews
Airscrews are marked as „A” and „B” - when assembling, pay special attention
to this marking. To find tips on assembly, please see fig. 6.
A – How to assemble an airscrew rotating clockwise
Assemble the airscrew marked as A in the corresponding motor (see: fig. 6).
Tighten up two screws with the use of a screwdriver and then put the protective
cover on and screw it in anti-clockwise.