17
Drum Selection Settings
Drum selection settings are pre-programmed at the factory for 4” Standard Lift type drums. Drum selection
must be made on doors with Standard or High Lift drums with a diameter greater than 4 inches, and also on
Vertical Lift doors. There are two drum settings available for sectional doors. Please note that door speed may
be affected by door weight, drum type, and balance, along with condition of door components and tracks.
Proper selection of the drum type is important for proper operation of the opener.
TO CHANGE OPENER drum selection:
1. Press and hold the SET/PRGM button on the opener until both LEDs turn BLUE then release.
2. Press the UP button twice.
3. Press PRGM button once.
4. The current setting will now be displayed. (SEE CHART).
5. Press either UP or DOWN buttons to adjust setting (SEE CHART)
6. Press PGRM button once to lock in the selection. LEDs turn BLUE then off.
7. Opener is now ready to set limits.
DRUM SELECTION CHART
DRUM TYPE
Long LED
Round LED
Standard 4 inch or less diameter drum
RED
RED
Standard or High Lift greater than 4 inch diameter or Vertical Lift
PURPLE
PURPLE
BLUE
Press to adjust. See
Chart for selection
Lock selection
X2
1
2
3
4
5
Operator drum selection settings must be
adjusted for use on Standard or High Lift
residential doors with drum diameters greater
than 4 inches. Drum selection settings must also
be adjusted for use on residential Vertical Lift
doors.
WARNING
!
Les réglages de sélection du tambour par l’opérateur
doivent être ajustés pour une utilisation sur des portes rés-
identielles à levage régulier ou élevé avec des diamètres de
tambour supérieurs à 4 pouces (10,16 cm). Les réglages de
sélection du tambour doivent également être ajustés pour
une utilisation sur des portes résidentielles à levage vertical.
AVERTISSEMENT
!
ADJUSTING FOR DRUM SELECTION
IMPORTANT NOTICE
IF DRUM SELECTION SETTING IS ALTERED, ALL FOLLOWING STEPS ON PAGES 18 THROUGH 20 MUST BE
PERFORMED TO LOCK IN THE FORCE PROFILE FOR PROPER DOOR OPERATION.
!
!
