![background image](http://html1.mh-extra.com/html/oventrop/1369531/1369531_installation-and-operating-instructions-manual_1662737012.webp)
|
12
1. Mounting
The unit must only be located in dry interior locations. It
is not suitable for installation in hazardous locations. Please
pay attention to separate routing of sensor cables and
mains cables.
The interface adapter is light and small enough to not re-
quire any form of mounting. It can be placed on a suitable
surface (pay attention to the ambient temperature!).
Four self-adhesive, skid-proof rubber pads are included with
the adapter. If necessary, these can be affixed to the corre-
sponding molds on the base part of the housing to ensure
a secure placement of the device without wall mounting.
If desired, the interface adapter can be mounted to a wall:
Î
Mark the desired hanging position on the wall.
Î
Drill and prepare the hole with a wall plug and screw.
Î
Hang the device onto the screw.
Î
Mark the position for the mounting screw (distance to
hanging point centre: 70 mm).
Î
Drill and prepare a hole with a wall plug.
Î
Hang the device and fasten it by means of the second
screw.
For wall mounting, opening the housing is not required.
Opening the housing is only required for access to the ter-
minals.
Î
To open the housing, unscrew the cover screw and pull
off the upper part of the housing.
Î
To close the housing again, relocate the upper part of
the housing and refasten the cover screw.
ATTEnTIOn! ESD damage!
Electrostatic discharge can lead to dam-
age to electronic components!
Î
Take care to discharge prop-
erly before touching the inside
of the device. To do so, touch a
grounded surface such as a ra-
diator or tap!
230 V~
S-Bus
PWM/0-10 V
note
An external mains connection to the pump can
be made.
connection scheme
Front view
Back view
Opening for the
mounting screw
Hanging
Molds for the
rubber pads
Cover screw
Upper
part of the
housing
Base part of the
housing
S-Bus
adapter