15
|
6. commissioning
The ”S-Bus interface adapter“ is equipped with a 7-seg-
ment LED display that can indicate the selected relay or the
current operational status.
1
= Relay 1
Regtronic RM
2
= Relay 2
3
= Relay 3
Regtronic RX
4
= Relay 4
5
= Relay 5
6
= Relay 6
7
= Relay 7
8
= Relay 8
9
= Relay 9
0.
= Relay 10
1.
= Relay 11
2.
= Relay 12
3.
= Relay 13
4.
= Relay 14
5.
= Relay 15
6.
= Relay 16
The relay addressed via the DIP switches is displayed by the
7-segment-LED at the front of the adapter.
As the LED can only indicate one figure, the decimal digit is
replaced with a dot when indicating relays 10 - 16:
If an error occurs, the display flashes an error code:
a
= The output addressing is faulty. The relay addressed
does not exist.
Î
Address a valid relay.
f
= The S-Bus connection is faulty.
Î
Check the S-Bus cable.
u
= The controller connected is not recognised by the de-
vice.
Î
Wait for about one minute. If the error code does not
disappear, contact the manufacturer.
When the interface adapter is connected to a controller
for the first time, a short initialisation phase will be run.
During this phase, the LED display flashes first the error
code
f
, then the error code
u
until the controller connect-
ed has been recognised. After a short time, the address of
the selected relay will be indicated.
If the error codes do not disappear or if an
a
is indicated
instead of the relay address, see chapter 6.3 for error code
descriptions and troubleshooting measures.
6.1 Initialisation phase
6.2 Indication of the selected relay
6.3 Error message
