5
/
11
Mounting and Installation
Cautions:
For added protection mount the fixtures in areas outside walking paths, seating areas, or in areas
where the fixture might be reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a minimum point
load of 10 times the device’s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an appropriate
safety cable.
Clamp Mounting:
The mover provides a unique mounting bracket assembly that integrates
the bottom of the base, the included “Omega Bracket,” and the safety cable rigging point in one unit (see the
illustration below). When mounting this fixture to truss be sure to secure an appropriately rated clamp to the
included omega bracket using a M10 screw fi tted through the center hole of the “omega bracket”. As
an added safety measure, be sure to attached at least one properly rated safety cable to the fixture using on
of the safety cable rigging point integrated in the base assembly.
DMX-512 control connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the
male 3-pin XLR input of the moving head. You can chain multiple
Moving heads be connected together through serial linking. The cable needed should be two core, screened
cable with XLR input and output connectors. Please refer to the diagram below.
DMX-512 connection with DMX terminator
