4
/
11
instructions under “Installation instructions”. Should you need any spare parts, please order
genuine parts from your local dealer.
Safety Instructions
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in
this user manual. If the device has been exposed to temperature changes due to environmental changes, do
not switch it on immediately. The arising condensation could damage the device. Leave the device switched
off until it has reached room temperature.
This device falls under protection-class I. Therefore, it is essential that the device be
earthed. The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and does not necessarily
mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for smooth
air flow, so there should be no shelter for fans and ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
Operation Instructions
-The moving head is for wash & Beam effect for on-site decoration purpose.
-Don’t turn on the fixture if it’s been through severe temperature difference like after transportation because it
might damage the light due to the environment changes. So make sure to operate the fixture until it is in normal
temperature.
-This light should be kept away from strong shaking during any transportation or movement.
-Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
-Don’t expose the fixture in overheat, moisture or environment with too much dust when installing it. And
don’t layany power cables on the floor. Or it might cause electronic shock to the people.
-Make sure the installation place is in good safety condition before installing the fixture.
-Make sure to put the safety chain and check whether the screws are screwed properly when installing the
fixture.
-Make sure the lens is in good condition. It’s recommended to replace the units if there are any damages or
severe scratch.
-Make sure the fixture is operated by qualified personnel who knows the fixture before using.
-Keep the original packages if any second shipment is needed.
-Don’t try to change the fixtures without any instruction by the manufacturer or the appointed repairing
agencies.
-It is not in warranty range if there are any malfunctions from not following the user manual to operate or any
illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
