Oval Smart EX DELTA II Series, Instructions Manual

Page: 19 / 54

D-582-3-E
Fig. .2
Fig. .
Fig. .3
Fig. .
Hex Socket Head
Screw
0 °
※
Latch
Cover
Shield Strip
Hex Soc. Head Screw
Sensor Leads
Turn
The preamplifier can be oriented to the desired
direction in 0 ° steps as shown in Fig. ..
NOTE: To change the orientation, hex key (JIS
B 8), nominal size , is required.
The preamplifier can be rotated by
loosening its four hex socked head
screws, but be sure to disconnect
sensor leads before attempting to
rotate it.
CAUTION: Turning the preamplifier with
sensor leads in place may
damage the sensor.
Procedure
Refer to Section 5, "EXPLODED VIEW AND
PARTS LIST, FIXED TYPE" on pages and 2.
① Turn off power.
② Remove the terminal box cover (Fig. .2).
NOTE: If the preamplifier is of explosionproof,
disengage the latch ( ※ ) before
removing the cover.
③ Separate the shield strip (Fig. .3).
④ Disconnect sensor leads from the terminal
block.
⑤ Loosen a total of four hex socket head screws
securing the preamplifier's neck (Fig. .).
⑥ Turn the preamplifier to the desired direction,
exercising care not to force the sensor leads.
⑦ When the preamplifier orientation has been
set, assemble in the reverse order of removal.
6.10 How to Change Preamplifier Orientation