Outwell 650826, Instruction Manual

Page: 2 / 17

2 3
IMPORTANT:
Read these Instructions for use carefully before connecting the regulato
to the gas cylinder or operating any appliance.
Keep these instructions for future reference.
INSTRUCTIONS FOR INSTALLATION
1) Ensure that all taps are turned off on the gas appliance and on the regulator (turn clockwise towards (-)).
2) Attach the hoses to the regulator and to the gas appliance respectively. Push the hoses all the way onto
the ribbed part of the hose nozzles. Use the hose clamps and tighten with a spanner or screwdriver.
3) Thread the gas cartridge onto the regulator. Hand tight only.
4) Open tap fully on the regulator (turn anticlockwise towards (+)).
• When the regulator is to be used outdoors, it shall be positioned or protected against direct penetration
by any trickling water.
• Check that seals (between the regulator and the gas cartridge) are in place and in good condition
before connecting to the gas cartridge.
• Inspect seal before using the regulator.
• Check for leaks at all joints using soapy water.
NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
• Do not use the regulator if it has damaged or worn seals.
• Do not use a regulator which is leaking, damaged or which does not operate properly.
Outlet
connection
Hose
Hose clamps
Tap
Inlet
connection
UK: INSTRUCTION MANUAL UK: INSTRUCTION MANUAL
Trinidad Gas Regulator I Trinidad Gas Regulator III
Model: 650826 / A500i-P159 650948 / A500i-P157
Type of gas: Butane Butane
Supply pressure: 0.3 - 16 bar 0.3 - 16 bar
Regulated pressure: 30 mbar 29 mbar
Flow rate: 0.8 kg/h 0.8 kg/h
Inlet Connection: 7/16” 7/16”
Internal diameter of hose: 8 mm 10-11 mm
Hose length: 80 cm 80 cm
Type of connections (inlet/outlet): G35/H50 G35/H51
Harmonized standard EN 16129 EN 16129
Seal
GASREGULATOR TRINIDAD I + III