Warning: Never unzip the zips on the protective
sleeves whilst the AirFrame Tubes are inflated. This
may result in the tube bursting or ballooning out of the
sleeve - causing damage to the tube and the sleeve.
Visit the website for Video Instructions
6
Fold the tent lengthways to
make a long thin straight line.
Packing away your awning.
Zip up all the windows and doors before deflating.
Unpeg the guy lines, storm straps and most of the pegs around the tent
- leaving the four corners pegged out.
Open each of the Dynamic Speed Valves in turn and press in the quick
release button. Leave the button pressed in.
Lay the tent flat on the ground.
Measure the width of the bag
up against the width of the fold-
ed tent to make sure the tent is
going to fit.
Begin to roll the tent as tight as
possible from the opposite end
of the Valves to expel all the air
as you roll.
Place the rolled awning on to
the bag and pull the sides up
round it. Finally, zip up the bag.
7
9. Lay out the inner tent inside the tent
and position it in the correct place with
the bedroom doors facing into the tent.
Start and the back of the bedroom and
clip it to the black clips on the floor.
10. Work your way around the elasticated
tabs connecting them to the canvas of the
tent. Make sure you line up the coloured
eyelets with the correct coloured elastic
to make sure you fit the inner tent cor-
rectly.
11. Finally, repeat the last few steps for
the second row of elasticated straps at
the front of the inner tent.