42.
At the peak, align
Ridge Boards
so they are flush together and secure them with
8 - 1 1/4”
screws
. To completely secure
Ridge Boards
, place
4 - 1 1/4” screws
into any of the remaining
Metal
Ridge Board Connector
holes. Complete both sides.
Important:
if there is a gap between Ridge
Boards, try pushing side walls closer together from outside. Walls should be 91” apart at top from
inside of wall plate to wall plate.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 18
41.
Take the inside - to inside measurment between
Top Wall Plates
and
Bottom Wall Plates
at
the front middle and rear of your shed. These measurements should each be approximatley 91”, but
more importantly, if they are not within 1/4” of each other than your walls are not square. Ensure walls
are square before attaching
Ridge Boards
together in
Step 42
.
91”
91”
91”
Metal Offsetting
Ridge Board
Connectors
Expert Advice:
It may be helpful to use
some clamps to help hold Ridge Boards
flush together while screwing.
