Control Board and Power Board
24
900-0054-01-00 Rev
A
Replacing the Control Board or Power Board
Figure 34 Bent Pin on Control Board
Figure 35 Inserting Control Board
Figure 36 Pins and Connectors
1. Inspect the connector pins on the
control board for any bends.
Straighten any bent pins with a flat
screwdriver or your finger.
2. Slide the control board into the power
board. Do not hit any components on the
power board.
3. Inspect the pins again before connecting
the control board to the power board.
4. Carefully align the control board connector
with the power board connector. Be sure
the pins and holes are lined up with each
other precisely.
5. When the pins and connectors line up,
push the control board into the
power board.
Connector Holes
Pins
Continued on next page.
