Fan and Button Board
22
900-0054-01-00 Rev
A
Figure 29 Inserting the New Button Board
Figure 30 Inserting New Push-nut
Figure 31 Reconnecting the Fan
5. Insert the replacement board and align
it with the four pegs.
6. Lay a replacement push-nut over each peg.
The push-nuts are not flat. Make certain to
place them so that the edges are lower and
the convex center is higher.
7. Using the wire cutters or long-nose pliers,
press along both sides of the push-nut so
that it is driven onto the peg. Continue
pressing until the push-nut is firmly against
the button board.
8. Repeat with the other three push-nuts
and pegs.
9. Reattach the connector for the fan.
10. If possible, reapply silicone sealant to
secure the fan connector and the four
push-nuts.
Proceed to the next section if you need to
replace the control board or power board.
If not, proceed to page 27
to begin
reassembling the charge controller.
