900-0054-01-00 Rev
A
9
FLEXmax Charge Controller Disassembly
If you have a FLEXmax 60, proceed with removing the chassis screws as described on page 10.
Removing the FLEXmax 80 Fan Cable
Figure 3 Removing Fan Cover
Figure 4 Removing Cable Jack
1. Remove the machine screw that secures the
fan cover.
2. Press both sides of the fan cover to release the
tabs. Pull up on the cover.
3. Remove the fan cover once the tabs have
cleared their slots. Keep the fan cover and
machine screw in a safe place.
4. Note the fan cable plugged into the jack.
6. Note the jack for the fan
cable, which is snapped
into the fan bracket.
5. Remove the fan cable
by squeezing the tabs
on either side of the
plug. You can do this
with your fingers, or
with a pair of long-
nose pliers.
Press
7. Remove the cable jack by
pinching the retaining
tabs on either side of the
jack, using long-nose
pliers. The jack can be
taken out through the
rear of the bracket.
Press
