50 | Ottobock
Operation
ParaGolfer
NOTICE
Risk of damage due to improper maintenance.
Inspect
the stand-up device for visible signs of damage at least
once a month and ensure all screw connections are tight.
Also maintain correct air pressure in the tyres.
NOTICE
Risk of damage during transportation.
Always lower the
stand-up device fully for loading or transportation.
INFORMATION
For optimal operation of the stand-up function, please
also observe the instructions in the brochure "Richtig Ste-
hen” (correct standing).
INFORMATION
Make sure a sufficient supply of power is maintained in or-
der to guarantee proper operation of the stand-up device.
INFORMATION
The motor of the standing function is not intended for con-
tinuous use, but only for short-term limited operation
(10 % use – 90 % idle time). General recommendation:
At a maximum load of 140 kg / 308 Ibs, 10 seconds of op-
eration should be followed by approx. 90 seconds of idle
time. In this regard, the stand-up device is considered in-
dependently of the driving function.
The drive function remains available even when the seat is
raised to the standing position. As soon as the seat leaves
the lowest position, the speed is reduced (creep speed) be-
cause the power wheelchair is less tip-resistant. This is indi-
cated by a snail symbol on the control panel (see fig. 19).
Fig. 18
Display of the standing function
Fig. 19
Display of the creep speed on the control panel
Summary of Contents for ParaGolfer
Page 1: ...Instructions for use ParaGolfer ...
Page 2: ......
