80
7.4.3 Connecting component with multiple mobile devices
The connection for a component can be stored on more than one mobile device. However, only
one mobile device can be connected to the component at one time.
If there is an existing connection between the component and a different mobile device, the fol
lowing information appears while the connection is being established with the current mobile
device:
Connect to this component?
Cancel
OK
Component was connected to
another device.
Establish connection?
►
Tap the "
OK
" button.
→
The connection to the last connected mobile device is
broken off and established with the current mobile device.
8 Use
8.1 Movement patterns in basic mode (mode 1)
8.1.1 Standing
Knee control through high hydraulic resistance and static alignment.
A stance function can be enabled by the O&P professional. Please see the fol
lowing section for further information on the stance function.
8.1.1.1 Stance function
INFORMATION
To use this function, it needs to be enabled in the adjustment software. It also has to be activ
ated using the Cockpit app (see page 85).
The stance function (standing mode) is a functional supplement to the basic mode (mode 1). This
function makes it easier, for example, to stand on an inclined surface for a longer time. The joint is
fixed in the flexion direction.
The stance function must be enabled by the O&P professional. In addition, the type of joint lock
ing (conscious/intuitive) has to be established by the O&P professional. Changing the locking
type using the Cockpit app is not possible.
Intuitive locking of the joint
The intuitive stance function recognises any situation that puts strain on the prosthesis in the flex
ion direction but where flexion is not permitted. Examples of this include standing on uneven or
sloping surfaces. The knee joint is always locked in the flexion direction when the prosthetic leg is
not fully extended, under some amount of load and at rest. Upon forward or backward rollover or
extension, the level of resistance is immediately reduced to stance phase resistance again.
The knee joint is not locked when the above conditions are met and a sitting position is assumed
(for example while driving).
Deliberate locking of the joint
1) Assume the desired knee angle.
2) Do not remove the entire load from the prosthesis.