76
7 Cockpit app
The Cockpit app enables switching from basic mode to the pre-configured
MyModes. In addition, information about the product (step counter, battery
charge level, etc.) can be retrieved.
The everyday behaviour of the product can be changed to a certain extent
using the app (e.g. while becoming accustomed to the product). The O&P
professional can use the adjustment software to track these changes at the
next appointment.
Information on the Cockpit app
•
The Cockpit app can be downloaded free of charge from the respective online store. For
more information, please visit the following website: https://www.ottobock.com/cockpitapp.
To download the Cockpit app, the QR code on the supplied Bluetooth PIN card can also be
read with the mobile device (requirement: QR code reader and camera).
•
The language of the Cockpit app user interface can only be changed using the adjustment
software.
•
The serial number of the component to be connected has to be registered with Ottobock the
first time it is connected. If the registration is not accepted, use of the Cockpit app for this
component will be limited.
•
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of
the foot must point up) or by connecting/disconnecting the battery charger. Bluetooth is then
turned on for approx. 2 minutes. During this time, the app must be started and used to estab
lish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see page 87).
•
Keep the mobile app up to date at all times.
•
Please contact the manufacturer if you suspect cybersecurity problems.
7.1 System Requirements
The functioning of the Cockpit app is assured on mobile devices that support the following oper
ating systems:
Only when "DUAL" marking is not present (
see page 60
•
Android:
version 4.0.3 or higher
Only when "DUAL" marking is present (
see page 60
)
•
The 4X441=* Cockpit app must be installed in version 2.0 or higher
•
iOS (for iPhone, iPad, iPod):
version 10.0 or higher
•
Android:
version 5.0 or higher
7.2 Initial connection between cockpit app and prosthesis
The following points should be observed before the initial connection:
•
Bluetooth of the component must be switched on (see page 87).
•
Bluetooth on the mobile device must be switched on.
•
The mobile device must not be in "flight mode" (offline mode), otherwise all wireless connec
tions are turned off.
•
The mobile device must be connected to the Internet.
•
The serial number and Bluetooth PIN of the component being connected must be known.
They are found on the enclosed Bluetooth PIN card. The serial number begins with the letters
"SN".