Inspection task
Check off after
completion
Check that wheels rotate freely and without axial runout
Check the driving characteristics of the wheelchair
Check the spoke tension
Drive wheels
Check the handrims for damage
Check that the fork is seated in the adapter without play
Check that wheels rotate freely and without axial runout
Caster wheels
Check that the mounting nuts are tight
Check for functionality and firm fit
Leg supports
Check leg supports for damage
Ensure that padding is in perfect condition
Padding/straps
Check adjustment straps for signs of wear
Check tyre pressure (see tyre sidewall)
Check for sufficient tread depth
(min. 1 mm)
Tyres
Check for damage
Oil pivot points and bearing points of control levers and movable
components
Oil/grease
Grease spokes
Check the general functionality of the mechanical adjustment
mechanisms
Final inspection
Driving test
10.3 Repair
WARNING
Prohibited repairs
Severe user injuries, damage to the product due to adjustment and installation errors
►
Only carry out the repairs described in this section. All other repairs may only be carried out by the qualified
personnel.
10.3.1 Inner tube, rim tape and tyre replacement
CAUTION
Improper tyre replacement
Injuries to the user due to incorrect installation, product damage
►
No person is permitted to sit in the wheelchair during tyre replacement
►
Before removing a wheel, support the product so it cannot tip over.
►
Always replace the tyres in pairs. Two differently worn tyres affect the directional stability of the wheelchair.
INFORMATION
TUFO tyres with tubes can be ordered as an option for this wheelchair type. They have to be replaced entirely in
case of damage.
Repairing flat tyres requires only the necessary tools and users may change tyres themselves if they wish:
Removal and preparing for installation
1) Carefully remove the tyre from the rim using appropriate tools.
INFORMATION: Take care not to damage the rim or the inner tube.
2) Unscrew the valve nut from the valve and remove the tube.
3) Repair the tube according to the directions in the repair kit or replace it with a new tube.
4) Before fitting the tyre again, inspect the rim bed and tyre inner wall for foreign objects. This could have caused
the puncture.
5) Before installing the tube, check that the rim band is in proper condition. The rim band protects the tube from
being damaged by the ends of the spokes.
33
Invader 480S26=20000_K
Maintenance and repair
Summary of Contents for 480S26 20000 K
Page 1: ...Instructions for use 3 Invader 480S26 20000_K...
Page 2: ...2 Invader 480S26 20000_K...
Page 37: ...37 Invader 480S26 20000_K...
Page 38: ...Invader 480S26 20000_K 38...