Otto Bock 17LA3, Instructions For Use Manual

Page: 12 / 112

2.2 Components/design (see Fig. 1)
Item Component Quant­
ity
Item Component Quant­
ity
1 Set screw 2 8 Bushing with collar 2
2 Stop pin (small) 2 9 Screw 1
Compression spring 2 3
Compression spring set
(only 17LA3=16/=20) 2
10 Flat head screw
(TORX®) 1
4 Stop pin 2 11 Axial washer 2
5 Bearing ball 2 12 Flat head screw
(Socket head) 2
6 Basic piece 1 13 Stop dummy 2
7 Nut 1
The scope of delivery does NOT include:
Item Component Article number
14 Joint bar 17LS3=12/-T, =14/-T, =16/-T, =20/-T
15 Foot stirrup 17LF3=12, =14, =16, =20
16 Lamination dummy 17LD1=12, =14, =16, =20
17 Shoulder screw (included in scope of delivery of 17LD1=*)
3 Application
3.1 Indications for use
The system ankle joints are exclusively intended to be used for the patient's
orthotic fitting of the lower limbs.
In case of unilateral use, the manufacturer recommends that the system
ankle joint be processed by means of lamination resin technique or carbon
prepreg technology. When used bilaterally, there is no limitation on the pro­
cessing technology used.
Use of the 17LA3=16-T or 17LA3=20-T system ankle joints in the C-Brace
orthotronic mobility system is permitted exclusively with the 17AO1 sensor
screw.
3.2 Indications
Partial or total paralysis of the leg muscles.
Indications must be determined by the physician.
12 | Ottobock