Otto Bock 17B105, Instructions For Use Manual

Page: 16 / 144

Using the lamination dummy
Required materials
For bar
width Lamination
dummy Lamination
bar Alignment
insert Shoulder
screw
16 mm 17Y126=16 17Y128=16*
17Y129=L16/
=R16 743Y56=2 501A1=10x7­
xM4
20 mm 17Y126=20 17Y128=20*
17Y129=L20/
=R20 743Y56=3 501A1=12x8­
xM6
> The plaster model is produced specifically for the patient.
1) Select the appropriate lamination dummy for the orthotic joint.
2) Disassemble the orthotic joint and remove the perlon cable with lock
(see fig. 2).
3) Insert the lamination dummy (see fig. 1, item 8) into the upper joint sec­
tion and install the orthotic joint.
4) Use the enclosed screws to mount the lamination bars on the orthotic
joint.
5) Insert the shoulder screw through the orthotic joint and affix it to the
alignment insert.
6) Laminate the orthosis according to the patient’s needs.
7) Remove the shoulder screw.
8) Disassemble the orthotic joint and remove the lamination dummy.
9) Cut the orthosis free and finish it.
Gluing in bars
Required materials:
636W28* special adhesive, degreasing cleaner
The bars must be glued in the insertion zones to ensure stability.
1) Clean the connecting surfaces with a degreasing cleaner.
2) Apply the special adhesive to the connecting surfaces.
3) Insert the bars.
4) Secure with the enclosed screws.
5) Allow to cure for at least
4 hours
.
INFORMATION: Final bonding strength will be reached after
16 hours.
16