OTARI FS-96, Operation Manual, Page: 13 / 28

■
Setting and Routing Memories: The FS-96 has two
configuration modes consisting of Setup mode and Routing
mode, and the preset memories are provided for each of the
configuration modes — setting memories and routing memories.
All system settings for the FS-96 are stored in these preset
memories. The setting memories are used to store the operation
settings made in Setup mode, excluding the signal routing
configurations. Also, the routing memories are used only to store
the signal routing settings made in Routing mode.
10 preset memories (No. 0 – 9) are provided for each of the
configuration modes and the operation settings can be altered
momentarily by changing the memory number selections. Since
the setting and routing memories can be selected separately, it is
possible to change the signal routing settings while the same
operation settings are maintained. Also, it is possible to change
the system settings while the same routing settings are
maintained.
NOTE: Combinations of setting and routing memories can be
stored to the PRESET keys on the front panel. Please refer to the
“
Using PRESET Keys ” section for the usage of the PRESET
keys (
☞
p.15 ).
■
Display of Current Preset Memories: The initial screen
displays the preset memory numbers that are currently used.
Note that the changes made in the configuration modes will be
stored into the preset memories which are currently used. When
changing the operation parameters, confirm that the desired
memory numbers are displayed on the initial screen. See the
“
Recalling Preset Memories ” section on this page for the
details of recalling preset memories.
■
INITIAL SCREENS:
NOTE: The contents of the preset memories will be updated
every time a parameter value is stored. It is recommended to
copy the memory contents before making large changes to the
various settings.
←
SETTING MEMORY No.
←
ROUTING MEMORY No.
SETTING MEM.: 0
ROUTING MEM.: 0
To change the preset memories to be used, follow the
instructions below to recall the desired memory numbers.
1. Press the ENTER key in the initial screen and select the
number of setting or routing memories.
The setting memory number is displayed with parentheses.
To select the routing memory number, press the Upper or
Lower Arrow keys.
■
SELECTING SETTING MEMORY
(USE TO MOVE SELECTION)
■
SELECTING ROUTING MEMORY
(USE TO MOVE SELECTION)
2. Use the right & left Arrow keys to select the desired
memory number and press the
ENTER key to store.
(USE TO CHANGE MEMORY NUMBER)
It may take a few seconds until the settings are changed
and the LCD shows “WAIT A MOMENT...” during this time.
SETTING MEM.: 1
ROUTING MEM.: 0
WAIT A MOMENT...
ENTER
SETTING MEM.:<1>
ROUTING MEM.: 0
SETTING MEM.: 0
ROUTING MEM.:<0>
SETTING MEM.:<0>
ROUTING MEM.: 0
ENTER
SETTING MEM.: 0
ROUTING MEM.: 0
February 2001 13
Operating Memories
Using Preset Memories
Recalling Preset Memories