Otai Pluto Fisheye, User Manual

Page: 25 / 89

always innovative
Setup
Networking
VLAN Tagging
For adding or deleting VLAN Tagging keep on adding VLAN and on choose on which interface it needs to be added and
what would be the TAG number.
Each time its done, please do not forget to do SAVE and when done APPLY for nal applying.
This section allows the user to add VLAN, create additional bridge, add interface to existing bridge and also allow
multiple DHCP servers. In special OTAi models its also allows the user to do BONDING.
Briding
Used to create more bridges. By default the unit has a mother bridge called BR0.
More bridges can be created by clicking on
ADD.
Name of the bridge needs to added. Recommended is br1 onwards. STP enabled or disabled can be chosen. By default it is ON.
Priority is also need not be changed.
Assign to Bridge
This allows adding new interfaces to new or old bridges. If an interface already a part of any bridge is added t o another
bridge then it automatically deletes itself f rom the older bridge.
The bridge to work on can be chosen and interface that needs to be added can also be chosen.
Note : If the Wireless is un-bridged then it will not be seen the BR0 table and should rst be bridged if it needs to be added to
another bridge. The VLAN created are all available in the Interface list, if they are not then VLAN were not properly added.
IMPORTANT : In Some INDOOR devices the LAN ports are named as VLAN1 and VLAN2. Here care should be taken that
any new VLAN port added should not be named VLAN1and VLAN2. Also its advisable that VLAN are named as per their TAG
no for easier understanding.
IMPORTANT
If a bridge is added then after
SAVE an APPLY Setting
needs to be done so that the new
bridge is visible in the
Current Bridging Table.