www.oster.com
www.oster.com
8
9
How to Blend Using the Jar and Blending Base
NOTE: If unit has the juice extractor accessory
assemble, please follow the instructions on the
section ‘AFTER USING YOUR JUICE EXTRACTOR”
1 Place the blender jar-to-go mug without the lid
on a flat dry surface with the open-end facing
up (Figure 1) and fill it with all the desired
ingredients
2 Place the blender assembly with blade upside
down on top of the jar opening, aligning the
locking tabs (Figure 2)
3 Turn the blender assembly counterclockwise (to
the right) to lock it to lock it securely (Figure 3)
4 Turn it upside down to be placed on the motor
base (Figure 4) as follows:
5 Align the arrows located in the top of the motor
base to make sure the ball notch is aligned with
the groove of base (Figure 5)
6 Raise the safety locking arms, and then lower
them to securely fit into the grooves and press
to lock (Figure 6)
7 Turn the on/off switch “I/O” on the front of the
unit to on position “l” and blend until mixture
reaches desired consistency.
8 When done, turn the on/off switch “I/O” to the
off position “O”.
9 Unlock the safety locking arms to release the
blade assembly with jar (Figure 7).
10 Lift the blade assembly with jar up and flip it
(Figure 8).
11 To remove blade assembly, turn it clockwise (to
the left) to unlock it and lift it up (Figure 9).
12 Screw on spill proof drinking lid on jar-to go
mug (Figure 10).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 9
Figure 10
Figure 8
Figure 6
Figure 7
Figure 5
Groove
Motor base and
blender assembly
alignment
Ball Notch
