ENGLISH
FITTING INSTRUCTIONS
Place opened garment behind back of knee.
1.
Note:
garment should be stretched lightly before first application.
Wrap the bottom portion of the garment around the calf and
2.
secure loosely.
Wrap the top portion of the garment around the thigh and secure
3.
loosely.
Position sleeve so the opening is centered over the patella. Adjust
4.
each of the 4 contouring pull points until the garment fits snugly
and comfortably.
Fasten the lower strap snugly across the calf.
5.
Fasten the upper strap snugly across the thigh.
6.
CHANGING EXTENSION STOPS
7.
Remove hinges from garment. Using a short Phillips screwdriver,
remove the screw from the center of the hinge plate .
8.
Locate extension stop positioned in the hinge between the upper
and lower arms. With arms slightly flexed, push the extension stop
from the back of the hinge through to the front, causing the stop to
pop out. Feed the hole end of the desired stop through the hinge
from the front to the back, with the curved side facing down and
the flat edge facing up.
9.
Make sure that the sharp extrusions on the flat end of the stop are
pointed downward. The flat end of the stop should be visible from
the front. Align the hole in the center of the hinge plate with the
hole in the extension stop. Replace and tighten the screw through
the hinge plate and extension stop.
WASHING INSTRUCTIONS
•
Remove hinges and close hook/loop fasteners before washing.
•
Use warm, soapy water, rinse thoroughly and line dry only.
•
Do not machine wash or dry.
•
For best performance results, rinse after every use.
WARNING:
this product is designed for warmth and compression only
and will not prevent injury. If you experience skin irritation, pain, or
discomfort while using this product, remove immediately and consult
your health care provider
Summary of Contents for UltraWrap
Page 1: ...I n s t r u c t i o n s f o r u s e UltraWrap...
Page 4: ...1 2 3 4 5 6...
Page 5: ...8 7...