Össur C180 ROCKET, Instructions For Use Manual

Page: 6 / 39

6
hole end of the stop through the hinge from the front to the back of
the brace, with the curved side facing down and the flat edge facing
up. Make sure that the sharp extrusions on the flat end of the
extension stop are pointed toward the distal portion (bottom half) of
the brace
(Figure 8) . The flat end of the stop should be visible from
the front of the brace.
5. Align the hole in the center of the hinge plate with the hole in the
extension stop. Replace and tighten the screw through the hinge plate
and extension stop. Replace the pad and cover. This procedure must
be completed on both the medial and lateral hinges.
6. Choose the appropriate extension stop (Blue = 0°, Black = 0-10°,
Dark Gray = 10-20°, Medium Gray = 20-30°, Light Gray = 30-40°)
• These numbers are approximate. Actual extension stop will vary from
person to person depending on anatomical differences. Appropriate
extension stop size is normally determined by health care provider.
LIMITED WARRANTY
This warranty covers all defects in materials and workmanship of your
new C180 Knee Brace. This Warranty covers the rigid carbon fiber brace
frame and AccutracTM hinges for 2 years. The warranty covers all other
materials, including straps, sleeves, liners and pads for six months from
the date of original purchase.
Ossur will repair or replace (at its option) any defective part covered
under warranty at no charge. Repairs necessitated by accident,
negligence, misuse or abuse by the purchaser are not covered. Also,
consequential and incidental damages are not recoverable under this
warranty. These limitations may not apply as some states do not allow
the exclusion or limitation of incidental or consequential damages. Only
the original purchaser is entitled to claim service under this warranty.
To obtain service under this warranty call our Customer Service
Department.