One Stop Systems
OSS-PCIe4-4UV-5
18
2
Hardware Set-up / Installation
The following steps will guide you through the installation of your One Stop Systems expansion system
CAUTION
Hardware installation shall be performed only by qualified service personnel per UL and IEC 60950-1.
Electrostatic Discharge (ESD) Warning
All PCI cards are susceptible to electrostatic discharge. When moving PCI cards, it is best to carry the cards in anti-static
packaging. If you need to set a PCIe card down, be sure to place it inside or on top of an anti-static surface. For more
information, see “Protecting Against Electrostatic Discharge” in the Preface.
WARNING
High voltages are present inside the expansion chassis when the unit’s power cord is plugged into an electrical outlet.
Disconnect the power cord from the AC outlet before removing the enclosure cover. Turning the system power off at the
power on/off switch does not remove power to components. High voltage is still present.
CAUTION
Before touching anything inside the enclosure, move to an ESD station and follow proper ESD procedures. Failure to do so
may result in electrostatic discharge, damaging the computer or its components. For more information, see “Protecting
Against Electrostatic Discharge” in the Preface.
2.1 Installation-Procedures Overview
Below is the concise version on how to set up the 4U Value GPU Accelerator System.
1.
Open Enclosure:
2.
Target Card Installation (If not installed):
3.
Host Card Installation:
4.
Link Cablse Installation:
5.
Connecting Power:
6.
Powering UP the Systems:
7.
Hardware Check:
8.
Re-install Top Cover:
9.
Verify Installation (via Operating System):
10.
GPU card or PCIe card Installation:
11.
GPU or PCIe card Check or Verification:
When installing 3
rd
Party PCIe card, start with one card first to determine if there are any software and hardware issues or incompatibility
problems that may occur. This will help you in troubleshooting the problem more easily and efficiently. If everything works well and no
configuration issues, you can proceed with the installation of the remaining 3
rd
party PCIe cards.
Always refer to or read “3
rd
party manufacturer installation guide” for further instructions.
Summary of Contents for OSS-PCIE-4UV-5-1
