8
In the event of a motor overload, the circuit breaker (transparent cap with red button) switches
off and the power supply is interrupted. It is located above the cable socket. After approx.
30 seconds the overload protection can be switched on again by pressing the red button.
The Orbiter is once again ready for operation when you reset the shaft to its basic position.
Handling the Wood Orbiter
Settings and preparations
1. Only use low-foaming, non-aggressive cleaning agents from Osmo: Wash & Care (internal), Water (external).
2. Exterior use: First apply the Wood Reviver "Power Gel" using the Osmo floor brush, a hard bristle brush or scrubber
and then move over the area with the Orbiter.
3. Only use the correct brushes for the correct purpose. (see brush table and pressure settings).
4. Fill the black tank with cleaning agent.
5. Plug in the Orbiter.
6. Raise the red button in the "up" position.
Recommended working method
1. Start the Orbiter by pressing the pedal and slowing pulling the shaft towards you.
2. Push the machine forwards and apply the cleaning agent sparingly, depending on the level of soiling
and the floor conditions, by pulling the white liquid lever.
Summary of Contents for Wood Orbiter
Page 2: ......
