SECTION 6 - JLG CONTROL SYSTEM
3121784
6-27
Here below the example shows on the image A
the case of machine model selected is wrong,
and on image B the case of machine model
selected is the right one.
3.
In case of the engine model selected is not cor-
rect with button n.7 (MOTOR) select the correct
one (for instance “D.RPM” is the diesel Hatz 1B40
and “G.13L” is the gasoline Honda iGX390).
4.
Press button n.3 (SAVE) to save the setting.
5.
Switch the main key OFF and ON again to restart
it.
6.
Press and release the remote control emergency
button to esc the SAFETY STATE.
7.
The display will show “LOAD CAL” and “INCL
CAL”, following the procedures of appendixes 2
and 1 calibrate the load cell system and the tilt
sensor.
8.
Following the relevant procedures set the other
settings, as ramps and currents.
Already Initialized Master Board
The machine system in some cases, specifically for
machine models different on a safety point of view, is able
to recognize if the machine model selected is not correct.
This verification is possible because on the load cell board
(ECM3) a series of contacts input depends on the machine
model.
As soon as another master board, already initialized on
another machine, is connected to its connectors, as well as
when the contacts on the load cell board (ECM3) have
been changed, machine will check if the machine model
selected on the master board corresponds to the machine
model where it is fitted on.
If the machine model selected on the master board does
not correspond to the machine model, the correct
machine model must be selected by the VERSION menu.
VERSION
MODEL:
LL1570
ENGINE
D.RPM
MOD. CODE
FAIL!
1 VERSION
7 MOTOR
3 SAVE
9 ESC
MACHINE MODEL
SELECTED IS WRONG
A
VERSION
MODEL:
LL1570
ENGINE
D.RPM
1 VERSION
7 MOTOR
3 SAVE
9 ESC
B
MACHINE MODEL
SELECTED IS OK
PERSONALITY SETTING
MACHINE
MODEL
ENGINE
X13JP
X370AJ
LL1370
D.RPM
B.13I
LITH.
X15JP
X430AJ
LL1570
D.RPM
B.13I
LITH.
Go
to
Discount-Equipment.com
to
order
your
parts
