OSHIMA OP-1200, Operating Manual, Page: 15 / 49

- 14 -
Yes
※
Without obeying the above instructions to maintain the
machine, the duration of machine will be seriously
decreased.
五、
TROUBLESHOOTINT
：
Does the lamp light up when
the power switch is turned on? Check the non breaker
Check the power supply
Check the fuse
Main switch is defective.
Does the driving motor run?
Can the speed be controller?
Is the belt being warped to the right (or the left)
？
Are the fabric and interlining etc being
touched with the elt warping stop switch
？
Set the pressure to “0”, and Ioosen the
temsion roller, then, return the belt to the
center (refer to the belt replacement). Maybe
the P.C. board or the belt warping prevention
limit switch made the belt warp.
No
Yes
Take out them
Dese it move after fuse has been
replaced?
One or some of the following parts is / are defective. Variable resistance,
motor or condenser. Also, mechanical troubles such as the slippage of v belt and burnt intermediate gear
causes the trouble.
Does the thermo-lamp light up?
Thermostat or sensor is defective if the lamp doesn’t light up when
the temperature is set at 300
℃
Does the SSR lamp blink when the KNOB of thermostat is turned and the termolamp is turned on and off?
The SSR lamp goes out when the thermolamp is lighting?
No
No
Yes
Yes
No
No
Yes
Yes
No
No