13
5. Fit front mudguard using the bolts, nuts & spacers provided (picture 1).
6. Remove disk pad spacer (picture 2 - this item is used for transport only).
7. Loosen caliper Allen bolts (Picture 5 - 5mm wrench) - so it will move side to
side so as to aid fitting of wheel.
1.
2.
3.
8A. Fitting Front Wheel.
16.0 E
(If you have a 16.0R or 20.0L please skip to 8B)
Position wheel between forks, ensure washers are on the outside of the forks
and tighten the 15mm nuts with the supplied multi spanner, making sure the
wheel is central to the forks. Continue to 9.
8B. Fitting Front Wheel.
16.0R or 20.0L ONLY
Position wheel between forks, with the quick release lever in the open position
finger tighten the skewer nut by hand. Release 1.5
– 2.0 turns and push the lever
to the closed position. Lever should be in the upright position as seen below.
9. Spin the front wheel and apply the front brake. Do this twice. While holding the
front brake on - tighten caliper bolts. This will centre the caliper and help to give
even wear of the pads and free running of the front wheel.
10. Adjusting rear caliper. Ensure rear wheel is clear of ground, turn by hand and
check brakes are not binding if they are loosen cap screws and adjust.
Be aware
that because the wheel can be moved back and forth for chain adjustment the
caliper does also - so make sure it does not rub on the outer diameter of disc.
Summary of Contents for 16.0 ECO
Page 28: ...27 WIRING DIAGRAM...
