OSBRiDGE 5GXi, Configuration Manual

Page: 7 / 32

ESSID - An ESSID is the name of a wireless network. All wireless devices on a common wireless
network must employ the same ESSID in order to communicate with each other.
Frequency – The frequency the device is currenly operating on.
Channel Width – Channel width the device is configured to operate. Available values are 20
MHz (standard width), 10 MHz (half width), 5 MHz (quarter width) and 40 MHz (802.11a Turbo
mode).
Preferred BSSID – MAC Address of the Access Point the device should connect to. If it is set to
00:00:00:00:00:00 then nly ESSID is taken into account.
PPPoE Authorization – Disabled or Enabled.
PPPoE Link Status – If the OSBRiDGE 5XLi/5GXi device succesfuly established PPPoE
connection to the PPPoE concentrator the status will show Connected. Otherwise it will show Not
Connected.
Fragmentation Threshold - The size at which packets are fragmented.
RTS Threshold - Minimum packet size to require an RTS (Request To Send) handshaking
limiting on-the air collisions. For packets smaller than this threshold, an RTS is not sent and the
packet is transmitted directly to the WLAN. For packets larger than this threshold the RTS/CTS
handshaking is established.
WLAN Speed – Configured wireless interface Data Rate.
Supported Data Rates – Wireless Data rates the device supports.
Available Data Rates are:
–
6, 9, 12, 18, 24, 36, 48 and 54 Mbps for regular 802.11a mode,
–
12, 18, 24, 36, 48, 72, 96 and 108 Mbps in 802.11a Turbo mode,
–
3, 4.5, 6, 9, 12, 18, 24 and 27 Mbps for 802.11a mode with 10 MHz channel width,
–
1.5, 2.25, 3, 4.5, 6, 9, 12 and 13.5 Mbps for 802.11a mode with 5 MHz channel width.
Supported Frequencies – Supported Frequencies for currently configured Regulatory Domain.
Distance to the Access Point – Configured distance between OSBRiDGE 5XLi/5GXi device and
the Access Point (or other Wireless Bridge) it is connecting to.
IP Address – Device IP address.
Subnet Mask – Currently defined subnet mask.
Default Gateway – Currently defined default gateway.
DHCP – Whether built in DHCP (Dynamic Host Configuration Protocol) server or client is disabled
or enabled.
Traffic Shaping – If enabled then device will use traffic shaping to limit data according to
defined rules. If disabled then there is no data traffic limiting.
Firewall – If enabled then device will use build in firewall to pass/block traffic according to
defined rules. If disabled then there will be no packet filtering.
Web Server on Port - Port number the build-in web server currently runs on.
Watchdog – Disabled or Enabled, depending on current Watchdog configuration.
Web Login Timeout – Currently configured Web Login Timeout variable.