OSBRiDGE 5GXi, Configuration Manual

Page: 10 / 32

PPPoE Username/Password – A PPPoE Username and Password that are required to create
PPP link to the PPPoE concentrator.
Currently supported PPPoE authorization types are CHAP, PAP, MSCHAP and MPPE.
Watchdog – If enabled then OSBRiDGE 5XLi/5GXi device will send 3 ICMP Echo Requests to the
configured IP address, each in 3 minutes interval. If there is no single ICMP Echo Reply to any of
these requests, then the device will reboot itself.
The device has also independent hardware watchdog built in, that checks for critical operational
parameters and reboots the device, should the system hang or become unstable. That watchdog
works all the time, regardless of the ping watchdog configuration.
Run Web Server on Port – Enter the port the build-in Web server should be configured to run
on.
Web Login Timeout – Enter the value the management Web session should be kept alive
without any action from the user.
Reset to Default Password – Password that is used to reset device to factory default settings
using OSReset software.
NTP Server – Configure IP address of the external NTP (Network Time Protocol) server
OSBRiDGE device will obtain current time from at startup time.
ETH Speed – LAN Port connection speed - available values are Auto (Auto Negotiation),
100Mbps FDX, 100Mbps HDX, 10Mbps FDX, 10Mbps HDX.
Last Good Config - If Enabled then device will keep copy of previously used configuration and
directly after reboot, if the built in watchdog triggers reset, will revert back to that configuration.