ORTHOSERVICE RO+TEN E112 10, Manual

Page: 20 / 60

Top III-S 10° · REF. E112
If necessary, remove the arm sling from the cushion and attach to the cushion
using the Velcro
®
fastener so that the orthotic lies to the left or the right-hand side.
Place the cushion laterally at the side to which the shoulder should be fixed,
close the waist belt with the push-in buckle fastener (fig. A) and tighten with the
corresponding Velcro
®
fastener (fig. A). Should the belt be too long, then it can
be shortened. To do this, cut the belt to the appropriate length and re-attach the
Y-shaped Velcro
®
fastener end.
Carefully insert the forearm into the arm fixation (fig. B); then close the arm
fixation with the respective Velcro
®
fasteners at the wrist (fig. C) and
the forearm (fig. D).
Insert the arm on the opposite side from the shoulder to be fixed through the loop
created by the shoulder and underarm belts (fig. E) and close the orthotic with the
push-in buckle fastener on the arm fixation (fig. F).
Close all the belts pertaining to the healthy shoulder with the respective Velcro
®
fasteners (fig. G); Back belt, underarm belt, shoulder belt and front belt.
If the belt is too long, it can be shortened; to do this, cut the belt to
the appropriate length and re-attach the Y-shaped Velcro
®
fastener end.
Check the placement of the underarm and neck padding; re-position the padding
if required (fig. H).
Attach the thumb support (and the softball for rehabilitation)
onto the cushion with the Velcro
®
fastener (fig. I).
A D A P T I N G F O R T H E D O C T O R / T E C H N I C I A N
1
2
3
4
5
6
7
English