TOOLING OPTIONS
PREPARATION AND SETUP
TONGUE TAB
The
1tRIPr
®
XD
comes standard with a Category 3/Category 4 tongue tab (152-806) with an insert for a 1 1/2”
tractor hitch pin size (Cat. 3) and an additional tab insert for a 2” (5.08 cm) tractor hitch pin size (Cat 4), which
can replace the Category 3 tab insert by removal of the snap ring above the tab insert and then removing the
tab insert from the internal socket. Also available is a Category 5 tongue tab (152-805) with a tab insert for a
2 3/4” (6.99 cm) tractor hitch pin size. These tongue tabs have an internal socket that fits the pin closely. This
eliminates implement backlash and improves control.
DANGER
CAUTION
1. Determine level mounting location. See page 6 - 4. Tractor drawbar heights vary.
2. Insert Tonge Tab in-between Tongue Tab mountin plates on Tongue.
3. Align bolts in correct holes, and fasten using nuts and lockwashers.
4. After tightening, tongue tab mount plates should clamp tight on Tonge tab. If gap exists it
may be necessary to shim inside with a flat or machined washer.
NOTE
:
IT IS IMPORTANT THAT THE TONGUE TAB MOUNT PLATES CLAMP
TIGHT ON THE TONGUE TAB. RECOMMENDED TOOLS: IMPACT WRENCH, 1 1/2”
IMPACT SOCKET, 1 1/2” END WRENCH.
Tongue
for 2” pin
152-806
Tongue Tab
Tongue Tab
mount holes
MOUNTING OF TONGUE TAB
AVOID CRUSHING.
Make sure all personnel are clear of the implement. Lower implement to the
ground, place tractor in park, turn off engine, and remove key.
USE BAR STANDS TO SUPPORT THE IMPLEMENT.
Park implement on a clean, dry,
and level surface. An uneven surface could cause implement to shift or fall, resulting in personal injury or
death, as well as implement damage. Securely support all implement components that must be raised.
Remove buildup of grease, oil, or debris prior to installing row unit mounts.
152-805
for 2 3/4” pin
4 - 1
MACHINE TO TRACTOR
CONNECTION (CONTINUED)
DANGER!
Escaping pressurized hydraulic fluid can penetrate skin, resulting in injury
or death. Relieve hydraulic system pressure before connecting or disconnecting trac-
tor. Use cardboard or wood,
NOT BODY PARTS,
to check for suspected hydraulic
leaks. Wear protective gloves and safety glasses or goggles when working with hydraulic
systems. If an accident occurs, see a doctor immediately for proper treatment.
CONNECT HYDRAULIC HOSES TO TRACTOR:
1. Four (4) hydraulic hoses are located on the machine tongue. Two (2) hoses possess
blue colored handles. Two (2) hoses possess green colored handles. The hoses with blue
handles are the wing fold hoses. The hoses with green handles are the machine lift and
lower hoses.
2. Each hose also possesses an “extend” symbol or a “retract” symbol. (See illustration)
Connect the “extend” labeled hoses to the pressure port of a tractor SCV remote. Connect
the “retract” labeled hoses to the retract port of a corresponding tractor SCV remote.
HOSE SYMBOL IDENTIFICATION
MACHINE TONGUE
HOSES
DANGER
3 - 8