Orthman 125-082-01-EN-OM, Operator'S Manual, Page: 46 / 86

PREPARATION AND SETUP
1TRIPR II Row Units OM-EN
4-18
7. Remove bolt (10) and pin (9) from AR trip linkage
package.
8. Remove lower bolts (12), spring pins (11), and pin
(13) from AR trip linkage package.
ORM000292
Figure 4-20
9. Position the AR trip linkage assembly (14) over the
main frame (15) and align pin holes.
10. Insert pin (9) and bolt (10).
11. Lower the AR trip linkage assembly into the tail
section (16) and align pin holes.
12. Insert pin (13) and spring pins (11).
13. Align springs and insert bolts (12).
ORM000293
Figure 4-21
14. Insert bolts (1), jam nuts (2), and left down-pressure
spring (3), see Figure 4-19 on page 4-17.
CAUTION
!
Avoid injury. Springs are under tension. Adjust spring
tension slowly. Failure to follow this information will
result in serious injury.
15. Tighten spring tension bolts to factory settings. See
“Automatic Reset (AR) Trip Linkage” on page 5-21.
9) Pin 12) Bolt (4 used)
10) Bolt 13) Pin
11) Spring pin (2 used)
9
10
11
12
13
9) Pin 13) Pin
10) Bolt 14) AR trip linkage assembly
11) Spring pin (2 used) 15) Main frame
12) Bolt (4 used) 16) Tail section
9
11
12
13
14
10
15
16