ORTEC RADEAGLET, User Manual

Page: 15 / 60

No stabilization since you switched on the instrument. After about 2–3 minutes, the status
should change to one of the following.
The instrument is stabilized. You can use the instrument.
The stabilization failed. A new calibration (see 3.5 , p. 32 ) is recommened.
2.4 Switch Off the Instrument
To switch off the instrument, enter the ADVANCED MODE and press NEXT until OFF is highlighted (Fig-
ure 7 , p. 15 ). Press SELECT to switch off the Instrument.
Figure 7: Highlighted OFF in advanced mode
To cancel the shut down process, press any key while the switch off screen (Figure 8 , p. 16 ) is shown.
2.5 Dose Rate Mode
2.5.1 Measuring the Ambient H*(10) Dose Rate
Once started, the instrument’s display starts up in the DOSE RATE MODE . It shows the ambient H*(10)
dose rate in units of µSv/h (this can be switched to mR/h). The dose rate is a primary physical quan-
tity measured by the device and indicates the strength of the current radiation field. The count rate is
displayed in counts-per-second (cps). Figure
9 , p. 17 shows the DOSE RATE MODE .
© innoRIID GmbH RADEAGLET User Manual• Software 2.1.16 • Document 1.32o • 2017-12-15 Page 15 of 60