Oromed ORO-N2 BASIC, Manual

Page: 46 / 70

– 46 –
Measure Procedure
Refer to picture 07
The monitor is designed to take measurements and store the measu-
rement values in
memory for two people using User ID A and User ID B.
1. Sit comfortably in a chair with your feet flat on the floor.
2. Select your User ID (A or B).
Stretch your arm forward on the desk and keep relaxing, make
sure the palm of hand is upturned. Make sure arm is in correct
position, to avoid body movement. Sit still and do not talk or move
during the measurement.
After the cuff has been appropriately positioned on the arm and con-
nected to the blood pressure monitor, the measurement can begin:
a) Press the Stop/Start button. The pump begins to inflate the cuff.
In the display, the increasing cuff pressure is continually displayed.
b) After automatically reaching an individual pressure, the pump
stops and the pressure slowly falls. The cuff pressure is displayed
during the measurement.
c) When the device has detected your pulse, the heart symbol in the
display begins to blink.
d) When the measurement has been concluded, the measured sys-
tolic and diastolic blood pressure values, as well as the pulse will
be displayed.
e) The appearance of this symbol signifies that an irregular heart-
beat was detected. This indicator is only a caution. It is important
that you be relaxed, remain still and do not talk during measure-
ments.
NOTE: We recommend contacting your physician if you see this in-
dicator frequently.
f) The measurement results are displayed until you switch the devi-
ce off. If no button is pressed for 1 minute, the device switches off
automatically.
g) When the unit is set to the 3 position on the right side of the de-
vice, 3 separate measurements will take place in succession after