Orolia Spectracom VersaPNT, Getting Started Manual, Page: 30 / 46

1.
In the VersaPNT Web UI, navigate to MANAGEMENT > NETWORK: Pin Layout .
The Pin Layout screen will be displayed.
2. Prior to assigning the new output, identify a pin pair in the pin Layout table that is
not used (Signal = "None") or not needed. You can Delete it, but you may also
simply assign the new PPS Output as described below, thus overwriting the existing
Input or Output.
3. Add a pin configuration by clicking the PLUS icon in the top-right corner. The Add
Pin window will display.
4.
Start with the Type Filter drop-down menu (second line in the window) and select
a signal type.
5.
From the Signal drop-down menu, select a signal.
6.
From the Pins drop-down menu in line 3, select the pin pair you chose in Step 2.
(Note that you will need 4 pins if you selected a RS485 signal Type.)
7.
Click Submit .
8.
In the Actions panel, click Apply Changes .
Navigation Pinout Configuration
VersaPNT has navigation-specific options that can be configured through the multi I/O con-
nector
"I/O signal mapping to Channels" on the previous page
To configure INS IN or OUT via RS232, follow the steps for "Configuring a new Input or
Output" on the previous page .
To configure any of the navigation options listed in the following chart(Options 1-8):
1.
Navigate to MANAGEMENT > NETWORK > Pin Layout as above and click to
PLUS sign in the top right corner..
2. Under Signal , select OPTION .
3.
Select the correct Pins from the drop-down menu that correspond to the Option
number.
4.
You can then click Submit. Be sure to also Apply Changes in the Actions menu.
SIGNAL TYPE
Option Number/
Channel Position
Pins
DCLS
RS- 232
RS-422
(n or p)
TTL
NMEA OUT Channel 4 9 & 10 1
PPS IN Option 1 & Channel 1 3 & 4 1
PPS OUT Option 2 & Channel 2 5 & 6 1
GPS IN Option 3 & Channel 3 7 & 8 1
26 VersaPNT Getting Started Guide Rev. 3.0
2.3 Assigning I/O Pins