Note:
For your reference, the command
helpcli
produces a list
of available commands. Press the
space
key to display the next
page, or the
b
key to display the previous page.
Note:
Should it become necessary to leave the command help
mode (indicated by a command line prompt ":"), press
Q
, or
Ctrl C
.
b.
If you are on a DHCP-enabled network, you
can assign an IP address by
enabling DHCP on your unit
. Use the
dhcp4set <x> on
command, (x
being 0/1 for ETH0 and ETH1, respectively).
Retrieve the IP address assigned to VersaPNT by typing the
net4
command.
The command should return the network settings, including the IP address.
c.
If you are NOT on a DHCP-enabled network, your unit's
IP address is set to
the default
for each Ethernet port (unless you have assigned a new static IP
address). You can access the unit via the default address with a PC configured
to the same subnet mask (255.255.255.0).
d.
You can
set a static IP address trough the CLI
using the command:
ip4-
set
<x>.<IP
address>.<subnet
mask>
Example:
ip4set
0
10.2.100.245 255.255.0.0
If required, also set your gateway address:
gw4set
<x>
<gateway
address>
.
Or, follow the steps below to set an IP address through the Web UI.
3.
Log In to the Web UI
a.
On a PC connected to VersaPNT via ETH0 or ETH1, start a web browser.
b.
Navigate to the IP address obtained or assigned in Step 2.
2.1 Network Setup
VersaPNT Getting Started Guide Rev. 3.0
19