MW1008P, user manual
22
The default value is YES, which means that the back-lighting will bright only if the
component value is inside permitted tolerance. To invalidate this function press the key below
option [NO]. Press the key below right arrow.
To save the current configuration, press the key below YES.
The configuration will be memorised in non volatile memory
and will be kept even after turning off the instrument. Choose
NO if you don't want to keep the parameters after turning off the instrument.
To use the sorting mode, the instrument should be configured in relative measurement by
pressing key
DISP.
. In sorting mode, the instrument places itself automatically in manual
mode and keeps the current impedance range. The user can change manually the range, but it
is simpler to measure a device in normal mode (auto) before activating sorting mode, the
instrument then keeping the most appropriate range. The manual mode allows to get a faster
response since the instrument doesn't have to search for the correct range for each measure. It
is besides one of the few cases where manual mode should be used.
SERIES AND PARALLEL MODELS
The key
MODEL
allows to choose the model to use. Please refer also to “PASSIVE
COMPONENTS” paragraph above. In case of doubt use the auto mode by a long press on this
key or use series model which is most generally appropriate.
DISPLAY MODES
The key
DISP.
Allows to select the display mode among three different ones. Successive
presses on the key
DISP.
allow to get the following display modes :
The measured value
The difference between value to the current value. The symbol
next to the parameter
indicates that this function is active. If the sorting mode is active, the message PASS-FAIL
will be displayed on the second line according to the value of the component, the nominal
value and the tolerance percentage defined by the user.
The difference in percentage to the current value. The symbol
and unit in %
indicates that this function is activated.
