MW1008P, user manual
10
audible indication when a DUT meets the programmed parameters.
Default value for the Pass Beep is SHORT. Pressing the
NEXT
key
will change the value to LONG or NONE.
Pressing the key under the right arrow will present
the option of turning the backlight on or off when a
valid component is measured. The default value is
YES.
Pressing the Menu key now will allow you to save
the selected configuration and place the LCR meter
in the Relative measurement mode.
To turn the Sorting mode OFF, press the Menu key
and step backward or forward using the appropriate
arrow key until the Sorting option is displayed. Press
the key under OFF. Press the Menu key and save this
configuration.
A
L
measurement
OFF
Set this feature to ON to measure the AL value of an
unknown toroid core. Press the ‘forward arrow’ key to
enter the number of turns on the inductor. To enter the
number of turns, select EDIT. A cursor will be displayed
under the last digit on the LCD. Pressing the Change key
will step the value of the digit over the cursor. Pressing
the
NEXT
key will move the cursor to the far left
position. When the number of turns has been entered,
press the
OK
key. For accuracy, a minimum of 10 evenly
distributed turns on the core is recommended.
1.
Pressing the Menu key and saving the current
configuration will place the LCR meter in
L+ AL
mode. The
AL
value will be displayed on the second line
of the display.
2.
To return to normal measurements, press the Menu key
and step backward or forward using the appropriate arrow
key to the AL display option. Select OFF and press the
Menu key again. Save the current configuration.
DISP.
The
DISP
.
key selects the manner that the value of a component will be displayed. If the
Sorting mode is disabled, pressing
DISP
.
cycles through the following display types:
The value being measured
The deviation of the value from the current value – The D symbol next to the
measured parameter indicates that this function is active.
