25
2. Set the channel and ID.
Set the channel by pressing
function button 2 < CH >, and set the ID by pressing
function button 3 < ID >. For details on the setting
procedure, please look at the sections on setting
Channel and ID.
3. Set the cameras shooting functions.
4. Set all the transmitters.
Repeat steps 1 to 3 and set
all the transmitters to ”Master unit” or ”Slave unit” in
the linked shooting mode. Set the Speedlites used in
linked shooting in the same way. When pressing the <
COMMAND MODE > button to change the setting of a
unit from “Slave unit” to ”Master unit,” the other trans-
mitters (or Speedlites) that were set to ”Master unit”
until then automatically switch to”Slave unit”.
5. Set up the slave unit cameras.
Check that the < LINK >
lamp of the slave unit is lit in green.
Set up all the slave unit cameras within approximately
30m / 98.4 ft. of the master unit camera.
6. Take the picture.
Check that the < LINK > lamp of the
master unit is lit in green and take the picture. The
slave unit cameras are released in coordination with
the master unit camera. After shooting with linked
shooting, the < LINK > lamp of the slave unit is briefly
lit in orange.
NOTE:
1. Shooting with manual focus is recommended for the
slave unit cameras.If focus cannot be achieved with
auto focus, linked shooting is not possible with the
corresponding slave unit camera.
2. There is a short time lag between the release of the
slave unit camera and the release timing of the master
unit camera. Perfectly simultaneous shooting is not
possible.
3. I f you fire multiple flash units at the same time during
linked shooting, the appropriate exposure may not be
obtained or uneven exposure may result.
4. When [ Flash firing ] in [ Flash function settings ] is set
to [ Disabled ],linked shooting cannot be performed.
