19
Wireless Multiple Flash Shooting
with Manual Flash Output
1. Set the flash mode to <M >
2. Set the number of firing groups.
While < MENU 1 > is
displayed, press function button 2 < RATIO > and set
the groups to fire. The setting changes as follows each
time you press the button:
(RATIO OFF)
→
(RATIO A:B)
→
(RATIO A:B:C).
3. Select a firing group
Press the function button < 3 Gr
>, turn the dial, select the desired setting flash output
group.
4. Set the flash output.
Selected group marked with red,
turn to move dial can set the flash output.
TIPS:
1. When ALL < RATIO OFF > is set, set A, B or C as the
firing group for the slave units. The flash will not fire if
it is set to D or E.
2. To fire multiple slave units with the same flash output,
select ALL < RATIO OFF > in step 2.
Wireless Multiple Flash Shooting with Manual
Flash Output MULTI: Stroboscopic Flash
This describes wireless (multiple flash) shooting using
manual flash. You can shoot with a different flash output
setting for each slave unit (firing group).Set all
parameters on the master unit.
Stroboscopic flash is an advanced manual flash shooting
method. When using stroboscopic flash with a slow
shutter speed, you can shoot multiple successive
movements within a single picture, similar to stop-motion
pictures. In stroboscopic flash, set the flash output,
number of flashes, and flash frequency (number of flashes
per second=Hz). For the maximum number of continuous
flashes, Please look at the end of this section.
