20
1. Set the flash mode to < MULTI >
2. Set the firing groups and the flash output.
Set the
number of firing groups and the flash output for each
group by referring to Manual mode guide on the
preceeding page.
3. Set the flash frequency and the number of flashes.
• While < MENU 1 > is displayed, perform the following
procedure: • To set the number of flashes, press func-
tion button 2 < MENU 1 >, turn the dial and press the set
key turn the dial and press the “set” . • To set the flash
frequency, press function button 3 < Hz>, turn the dial
and press the “set” .
NOTE:
1. To avoid degrading and damaging the flash head of the
slave unit due to overheating do not shoot repeatedly
with stroboscopic flash more than 10 times. After shoot-
ing 10 times, allow a rest time of atleast 15 min.
2. If you shoot repeatedly more than 10 times, the slave
units safety function may activate and restrict the flash
firing.If this happens, allow a rest time of at least 15 min.
In stroboscopic flash, to ensure that the shutter stays
open until the end of the continuous flashes, set the
camera with a shutter speed calculated with the following
equation:
Number of flashes
÷
flash frequency = shutter speed
For example, if the number of flashes is set to 10 (times)
and flash frequency to 5 (Hz), set the shutter speed to 2
sec. or longer.
Calculating the Shutter Speed
Wireless Multiple Flash Shooting with Manual
Flash Output MULTI: Stroboscopic Flash (cont.)
