13
5. Set the flash mode to < ETTL >.
Press the < MODE > button on the master unit and set
the flash mode to < ETTL >. The slave unit is set automat-
ically to < ETTL > during shooting via the control from
the master unit.
6. Check the operation.
1. Check that the < LINK > lamp is lit in green. Otherwise,
please check again the connection parameters, when
the recycling of all the flash units is completed, the
master unit’s charge lamp lights.
2. In optical mode, check whether all subordinate flash
charging is complete. According to the main control
unit test flash button (charge indicator).
3. The slave unit flashes. If the slave unit does not fire,
check that it is placed within the operation range.
7. Take the picture.
Set the camera and take the picture. The confirmation lamp
lights for 3 sec.
NOTE:
If the <LINK> lamp is red, radio transmission has not
been established . Check the transmission channels and
wireless radio IDs of the master unit and slave unit. If you
cannot connect, turn the power off and on again .
TIPS:
1. You can press the depth-of-field preview button on the
camera to fire the modeling flash.
2. If the slave auto power off, press the master units test
flash button to turn on the slave unit. The test flash
cannot be fired while the camera’s timer is operating.
3. The autoflash system (E-TTLII/E-TTL) depends on the
camera used and is set automatically. Note that <ETTL>
is displayed on the LCD panel for both systems.
