Orlit ROVER RT TTL, User Manual, Page: 15 / 20

15
For optimal performance, the battery should be maintained by following
these instructions. Only use the Orlit battery charger 14.8V 2500mAh.
1)
Battery capacity check
Press CHECK button to check current battery capacity.
4 sections: 100~75% / 3 sections: 75~50% / 2 sections: 50~25%
1 sections: 25~5% / 0 sections: less than 5%
2) Lithium battery care and maintenance
Lithium battery (DC 14.8V 2500mAh), the new battery achieves
optimal performance only after two or three complete charge and
discharge cycles. Li-ion battery can be charged and discharged
approximately 300 times. When the flash recycle time increases or
the battery usage time shortens, replace the cell with a new original
Orlit battery.
Environmental temperature effects the useful life and recharge efficien-
cy of the battery. Battery capacity is reduced if allowed to overheat
or freeze. The battery works best in an ambient temperature range of
59~77F. When environment temperature is lower than 32F, the battery
capability will be limited even at full power. Charge a depleted battery
immediately to protect the capacity and life span. Do not ignore the low
voltage warning on the battery level indicator.
To avoid battery deterioration, please wait 10 minutes to cool the bat-
tery every time after using the Rover RT TTL. Turn off the power switch
or disconnect with charger before taking out battery. Please complete a
full recharge if the unit has not been used for 3 months.
BATTERY PRECAUTIONS
Do not short circuit. Do not expose to rain or immerse in water. This battery is not waterproof.
Keep out of reach of children. Do not keep on charger for more than 24 hours. Store in dry, cool,
ventilated places. Do not put near or into fire. Dead batteries should be disposed according
to local regulations. If the battery had not been used for over 3 months, please complete a full
recharge.
BATTERY MAINTENANCE
Battery release button battery lock charging socket
Attaching the Battery Module :
1. Align battery module lock tab to the left side
of the power pack.
2. Slightly press the power pack down over the
right side of the battery.
3. The battery is locked in place when you hear a
‘click’ sound
To release the battery, press the battery release
button