Imported by
AIC International, 44980 Ste-Luce-sur-Loire, France
Date, time, and battery charge level.
Fine particle (PM2.5) level
Formaldehyde (HCHO) level
TVOC level
Temperature and Humidity
Colour coded rating.
ON/OFF and settings button.
UP button “+”
DOWN button
Return button
Set-up and Installation:
Unpack the device and make sure all the accessories are present, then follow these instructions.
Step 1: Charging the battery.
Plug the micro-USB end of the charging cable into the micro-USB port
on the side of the device then connect the other end to the USB port of a power source (computer,
mains adapter, etc.).
The display lights up and the battery charge level bar shows charging progress (1).
A red power-on
LED comes on at the top of the tester
. Once the battery is completely charged, the charge level
indicator stops blinking and the power-on LED turns green. Disconnect the cable.
The battery charge
life is 4 hours.
The device needs 200 seconds to warm up and adapt to the atmosphere. A countdown of this time in
seconds is shown on the TVOC display line (
4
). To recover from the effects of packaging and
shipping, the device must be placed outdoors in a dry, protected area for 30 minutes in order to clear
the sensors before first use.
Important:
Do not make any adjustments during the warm-up period.
Unfold the stand and position the air quality tester in a convenient place in the room, office,
warehouse, etc. Choose a location where the sensor air vents on the front and back of the device are
completely unobstructed; this will ensure the device functions properly.
Keep the device well away
from any direct source of pollution as well as any liquids, heat sources, flammable products, and
magnetic fields. The measurements made are shown on the display.
The tester makes a slight noise during use. This is normal and is caused by the sensor cooling fan.
The noise stops when the tester is turned off.
Important:
if the screen becomes dim and/or the battery charge level bar (1) starts blinking,
it means the charge is running low. Recharge the battery fully.
To turn the tester on or off, press and hold in button (
7
).
