FIGHT TECH BY ORION
7
•
Please be sure to inspect unit for all listed materials before proceeding with assembly
instructions.
•
Unit must be properly secured to the floor.
•
Use equipment at your own risk, and always consult a physician before starting any new
exercise.
Assembly of Unit
Place (1) collar at the approximate
height desired for the rotating
target (user’s shoulder height is
recommended). Secure in place
using (2) set screws with the 3/16”
allen wrench.
Place (1) washer followed by (1)
thrust bearing, and then (1) washer
over the shaft.
The rotating arm will be delivered
assembled. Remove half of the
assembly. Place the (long) rotating
arm over the assembly remaining
on the shaft. Tighten bottom
collar using the 3/16 allen wrench
provided. Turn down tight with
the arm in position to your
shoulder.
7
8
9
10
11
Use included air pump in order to
Moisten the needle and fill the
head target as shown above. Be
sure not to overfill-only fill to 90%
full.
Lower the top assembly over the
top of the arm down the shaft.
Lower the top collar down the
shaft trapping all of the parts
together. Apply a small amount of
pressure to the collar and tighten
top collar.
Place the head target (item 10)
onto the unit in the orientation
shown above. Secure in place
using (2) set screws with the
3/16” allen wrench.
12
